Turning Off; Security Measures; Daily Maintenance; Periodic Maintenance (Once Every 2-3 Days) - CombiSteel 7075 Serie Mode D'emploi

8. TURNING OFF

1. The device is turned off by holding down the ON/OFF button for 2 seconds.
2. Bring the switch that supplies the device to "0" position.
3. Take the washed product out by lifting the upper cover and close the cover.
4. Close the water inlet valve.

9. SECURITY MEASURES

1. If the cover is opened while the device is operating or if the cover is not completely closed after it is started,
the device will stop operating. Device will start operating once the cover is shut.
WARNING: If there are any damages on the energy input cable or any water leakage on the release pump, the
device needs to be shut down and an authorized service must be notified.

10. DAILY MAINTENANCE

1. The wash water must be renewed at least two times a day or when the water loses its ability to clean due
to dirty particles. Washing performed with dirty wash water causes bad washing results, along with
detergent, polisher and power wastage.
2. Before starting maintenance activities, turn off the power switch that the device is connected to.
3. Be careful so that the dirty water outlet is not blocked.
4. Check whether the washing and rinsing arms can turn easily. Check the water sprays and if they are blocked,
clean the holes with a thin stick.
5. Leave the cover open after cleaning the device.
WARNING: In order not to damage the electrical equipment, clean the device with a direct or high
pressured water.

11. PERIODIC MAINTENANCE (once every 2-3 days)

1. Never do maintenance while the device is powered.
2. As shown in Figure 1, materials that can cause blocking must be cleaned by taking out the nozzles of the
water sprays.
3. Clean the outer surfaces of the device with a wet and soapy cloth. While cleaning the surface of the device,
do not use materials that can leave marks on the surface such as detergents, wire brushes etc. which have
abrasive content.
4. Clean the device warmers with an anti-lime once a week.
5. Take out and clean the pump front filter in certain periods.
6. If the device will not be used for a long time, the surfaces need to be covered with Vaseline in thin layers.
7. Contact the authorized service in case a dangerous situation is noticed in the device. Do not let unqualified
people to interfere the device.
8. After a certain operating duration, depending on the hardness of water, the calcium and magnesium in the
water can cause the forming of boiler scale on the interior surfaces of the wash tank, boilers and interior
sections of the water pumps which can affect the devices performance. For this reason, a boiler scale
cleaning process must be performed by a qualified technician over time.
9. Maintenance of the boilers, emptying the water inside the boiler and pump and cleaning them must be
performed by qualified people periodically.
10. If there is a danger of freezing during the times when the machine hasn't worked for a long time, the wash
pump and boiler must be emptied.
11. Contact the authorized service in case a dangerous situation is noticed in the machine. Do not permit
unqualified people to interfere the device.
www.combisteel.com
8