Empire FRBC Instructions D'installation Et De Fonctionnement page 5

REMOTE ON/OFF RECEIVER INSTALLATION INSTRUCTIONS
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
Remote ON/OFF Receiver - Cast Iron Series
Use the following steps to attach the remote receiver to the cast iron stoves:
1. Attach, from left to right, the slide-on cover plate onto the remote receiver. ON will be to the top and OFF will be to the
bottom on the slideon cover plate.
2. Push the receiver slide button onto the receiver slide switch. Reverse installation of the slide button if it is off center.
3. Attach velcro loop on the left side of the valve cover support.
4. Attach velcro hook onto remote receiver. The word TOP on the remote receiver should be to the top when installed
onto valve cover support.
5. Attach velcro hook on remote receiver onto velcro loop on valve cover support.
Remote ON/OFF Receiver - Direct Vent Fireplaces and Vent-Free Fireplaces
Use the following steps to place the remote receiver in the bottom of the inner casing assembly, adjacent to the gas valve.
1. The remote receiver can not be placed behind the gas valve.
2. When facing the appliance, the remote receiver must be placed to the right of the gas valve.
Remote ON/OFF Receiver - Vent-Free Log Sets (Millivolt System)
Use the following steps to place the remote receiver adjacent to the gas valve.
1. The remote receiver can not be placed behind the gas valve and burner assembly.
2. When facing the appliance, the remote receiver can be placed to the right of the gas valve and burner assembly or
under burner pan left of gas valve.
Remote ON/OFF Receiver - DV-210 and DV-215
Attention: Do not install remote receiver inside furnace.
Use the following steps to attach remote receiver.
1. Attach remote receiver at bottom of either side on outer casing.
2. If furnace is installed high enough above floor, attach remote receiver on the underside of furnace.
Remote ON/OFF Receiver - DV-25 and DV-35
Attention: Do not install remote receiver inside furnace.
Use the following step to attach remote receiver.
1 Attach remote receiver to the underside of the furnace, adjacent to the right of piezo ignitor.
Remote ON/OFF Receiver - DVC-35, DV-55, FAW-40 and FAW-55
Use the following step to attach remote receiver.
1. Attach remote receiver in the interior, bottom of furnace, adjacent to gas valve.
Remote ON/OFF Receiver - GWT-25, GWT-35 and GWT-50
Use the following step to attach remote receiver.
1. Attach remote receiver to wall sill or floor plate.
Remote ON/OFF Receiver - DV-20E, DV-40E and DV-55E
Use the following step to attach remote receiver.
1. Attach remote receiver in the interior of the furnace, adjacent to the right of pressure switch.
17808-5-0220
Attention: Velcro loop and hook are not necessary for all installations.
Empire Comfort Systems Inc. • Belleville, IL Page 5