Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WIRING INSTRUCTIONS
A qualified electrician or a gas technician who is familiar with the gas appliance and gas valves that will be operated by
this remote should install the remote control system. Incorrect wiring connections WILL cause damage to the gas valve or
electronic module operating the gas appliance and may also damage the remote receiver.
WIRING MILLIVOLT VALVES
The remote receiver is connected to the millivolt valve using the TH (thermostat) terminals on the terminal block on the
millivolt gas valve.
Connect 18 gauge solid or stranded wires from the remote receiver to the gas valve.
Operation of the remote receiver is similar to that of a thermostat in that both turn the gas valve on and off based on
input signals. A thermostat's input signals are different temperatures. The remote receiver's input signals come from the
transmitter.
Connect each of the two wires leading from the TH terminals on the millivolt gas valve to either of the two wire terminals
on the remote receiver. Normally it does not matter which wires go to which terminal.
For installing onto Empire Comfort Systems products, see page 6.
The remote control receiver can be connected, in series, to a 24VAC transformer to the TR (transformer) terminal on the
ELECTRONIC MODULE. Connect the hot wire from the 24VAC transformer to either of the wire terminals on the remote
receiver. Connect another wire (not included) between the other receiver wire terminal and the TH (thermostat) terminal
on the ELECTRONIC MODULE.
System Check
MILLIVOLT VALVES
Light your gas appliance following the lighting instructions that came with the appliance. Confirm that the pilot flame is on;
it must be in operation for the main gas valve to operate.
•
Slide the 3-position button on the remote receiver to the ON position. The main gas flame (i.e., the fire) should ignite.
•
Slide the button to OFF. The flame should extinguish (the pilot flame will remain on).
•
Slide the button to REMOTE (the center position), then press the ON button on the transmitter to change the system
to ON. The main gas flame should ignite.
ELECTRONIC IGNITION SYSTEMS
•
Slide the 3-position button on the remote receiver to the ON position. The spark electrode should begin sparking to
ignite the pilot (the pilot may ignite after only one spark). After the pilot flame is lit, the main gas valve should open and
the main gas flame should ignite.
•
Slide the button to OFF. The main gas flame and pilot flame should BOTH extinguish.
•
Slide the button to REMOTE (the center position), then press the ON button on the transmitter to change the system
to ON. The spark electrode should begin sparking to ignite the pilot. After the pilot is lit, the main gas valve should
open and the main gas flame should ignite.
General Information
MATCHING SECURITY CODES
Each transmitter can use one of 255 unique security codes. It may be necessary to program the remote receiver to
LEARN the security code of the transmitter upon initial use, if batteries are replaced, or if a replacement transmitter
is purchased from your dealer or the factory. When matching security codes, be sure slide button on the receiver is in
the REMOTE position; the code will NOT "LEARN" if the slide switch is in the ON or OFF position. Program the remote
receiver to LEARN a new security code by pushing in the LEARN button on the top of the remote receiver and then
pressing the MODE button on the transmitter. A change in the beeping pattern, at the receiver, indicates the transmitter's
code has been programmed into the receiver. When an existing receiver is matched to a new transmitter, the new security
code will override the old one.
The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are
unsuccessful in matching the security code on the first attempt, wait 1-2 minutes before trying again – this delay allows
the microprocessor to reset its timer circuitry – and try up to two or three more times.
17808-5-0220
Empire Comfort Systems Inc. • Belleville, IL
Page 3
Publicité
Table des Matières
