VONROC WB502XX Traduction De La Notice Originale page 10

EN
DESCRIPTION
The numbers in the following text refer to the pic-
tures on pages 2-7.
# Description
A Legs
B Bottom long support bars
C Bottom short support bars
D Top long support bars
E Top shot support bars
F Top middle support bar
G Left drawer bracket
H Right drawer bracket
I Pegboard supports
J Drawer with boards and liners
K Drawer handle
L Horizontal pegboard support
M Vertical pegboard support
N Pegboard
O Work surface
P Plastic feet
Q Pegboard hooks
R Bolts
S Nuts
T Short screws
3. ASSEMBLY
Study each figure and identify the
components required with reference to the
contents table above.
Note: A rubber mallet may be used on the beams
and braces to seat the parts properly. A hammer
can also be used, providing one uses a cloth or a
block of wood between the hammer head and the
parts to prevent damage. Tap gently and be sure
the parts are straight and fully engaged.
Fig. A
Attach the plastic feet to the legs.
10
Fig. B
Build up the basic frame.
Fig. C
Attach the drawer brackets to the basic frame.
Quantity
4
Fig. D
Attach the support bars to the basic frame.
2
2
Fig. E
2
Mount the legs to the pegboard supports by using
bolts and nuts.
2
1
Fig. F
1
Attach the pegboard support frame.
1
Fig. G
2
Mount the middle support bar.
1
Fig. H
1
Attach the work surface to the frame by using short
1
screws.
1
1 Fig. I
Attach the plastic feet to the upper corners of the
1
frame. Insert the drawer into the drawer brackets.
8
15
Fig. J
Mount the handle onto the drawer by using bolts
26
and nuts.
26
4
Fig. K
This figure shows the finished workbench.
4. MAINTENANCE
The workbench is designed to function
faultlessly for a long period and with a
minimum of maintenance. Extend its
lifespan by regularly cleaning the machine
and treating it correctly.
Cleaning
Regularly clean the workbench, preferably after
each use. Clean with a suitable proprietary house-
hold cleaner and a soft dry cloth. Do not submerge
your workbench in water or any liquid for any rea-
son. Do not use solvents (petrol, alcohol, ammonia,
etc.) as they will damage the plastic parts.
WWW.VONROC.COM