Beha-Amprobe SF100 Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
50V (25V)rms AC. The values in brackets are valid for limited
ranges (as for example medicine and agriculture).
Measurements in dangerous proximity of electrical installations are
only to be executed when instructed by a responsible electrical
specialist, and never alone.
If the operator's safety is no longer ensured, the instrument is to
be put out of service and protected against use. The safety is no
longer insured, if the instrument:
• shows obvious damage
• does not carry out the desired measurements
• has been stored for too long under unfavourable conditions
• has been subjected to mechanical stress during transport.
Prior to usage, inspect instrument for external damage. Prior to any
operation, ensure that connecting leads used and electronic load
are in perfect condition.
The BEHA-AMPROBE SF100 may only be used in systems complying
with the nominal voltages indicated in the technical data section.
If the instrument is subjected to an extremely high electro-magne-
tic field, its functioning ability may be impaired.
Never try to disassemble battery cells !The battery contains highly
alkaline electrolyte. Danger of causticization ! If electrolyte gets in
contact with skin or clothing, rinse immediately with water. If elec-
trolyte gets in contact with the eyes, immediately flush by using
pure water and consult a doctor.
Never try to make contact between both battery cell poles, for ex-
ample by using a wire connection. The resulting short-circuit cur-
rent is very high and causes extreme heat. Danger of fire and ex-
plosion !
• Never throw battery cells into a fire as this could cause an explosi-
on.
• Never expose batteries or accumulators to humidity.
• When replacing or changing the battery, make certain of correct
polarity. Batteries with reversed polarity can lead to instrument
destruction. Furthermore, they may explode or ignite.
• Only use batteries as describet in the technical data section
Avoid any heating up of the instrument by direct sunlight to ensu-
re perfect functioning and long instrument life.
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sf100-d

Table des Matières