Install The Tines - Southland SFTT142.1 Manuel De L'opérateur

Assembly
(Continued)
• Save all instructions
B
Assembly Instructions (Continued)

Install the tines

(See Figure 3)
1 . Slide the tines onto the tine axle . Install the internal tines
first . Sharp edge of the front and top tines should face
down and forward to till the ground . Insert the
M10 x 50 bolt with lock nut provided to secure the
inside tines . Use one flat washer under the head of the
bolt and one under the locknut . Tighten securely .
2 . For wide 21" tilling, install the outside tines in the way
that the long half of the tine tube faces towards the
inside tines . For narrow 16" tilling, install the outside
tines in a way that the short half tine tube faces towards
the inside tines .
3 . Insert the Lynch pins to secure the outside tines . Install
Lynch pins so the direction of the pin is from front-
to-back and the wire loop pivots over the top of the axle .
Secure by expanding the wire loop so it extends over
and captures the end of the pin . (Fig 3)
Install the drag bar
1 . Insert the drag bar into the bottom of the wheel bracket
assembly . (See Figure 4)
2 . Insert the pin through the bracket and the middle
hole of drag bar and secure with flat washer and
hairpin cotter . (See Figure 4B)
Install lower handle
(See Figure 5)
1 . Orient lower handle with upper square holes as shown .
Align lower handle holes with respective holes in the
frame and loosely install two M10 x 25 mm bolts, lock
washers and flat washers on each side .
2 . Using a wrench, tighten bolts securely on each side .
3 . Remove hairpin cotter and washer from clevis pin in
lower handle . Install link using the upper hole to clevis
pin and reinstall washer and hairpin cotter . Repeat
on opposite side .
Questions? Call Toll Free at 1-800-737-2112
Sharp edge of tine should face down to the ground .
ENG - 9
Copyright © 2018 MAT Engine Technologies, LLC
Figure 3
Figure 4
Figure 4B
Figure 5