Install The Tines - Southland SFTT140 Manuel De L'usager

Assembly
(Continued)
• Save all instructions

INSTALL THE TINES

(See Figure 5)
1. Slide the tines onto the tine axle. Install the internal tines
first. Sharp edge of the front and top tines should face
down and forward to till the ground. Tighten the M10 x 50
bolt with lock nut provided to secure the inside tines.
2. For wide 21" tilling, install the outside tines in the way
that the long half of the tine tube faces towards the
inside tines. For narrow 16" tilling, install the outside
tines in a way that the short half tine tube faces towards
the inside tines.
3. Tighten the M8 x 50 bolt with the locknut provided to
secure the outside tines.
INSTALL THE OUTSIDE TINE SHIELDS
1. Each outside tine shield can be installed on either side
of the main tine shield.
2. Place the outside tine shield underneath the main tine
shield and align the holes.
3. Secure the outside tine shield to the main tine shield
with (3) M6 x 16 bolts washers and lock nuts.
Questions? Call Toll Free at 1-800-737-2112
(See Figure 5)
9
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
Sharp edge of tine should face down to the ground.
Copyright © 2015 MAT Engine Technologies, LLC
Figure 5