Air Supply; Lubrication - Napa 6-1078 Mode D'emploi

AIR SUPPLY

Tools of this class operate
on a wide range of air
pressures. We recommend
that air pressure measures 90
psig at the air inlet while in
use. Low pressure (less than
90 psig/6.2 bar) reduces the
speed and performance of all
air tools. High pressure (over
115 psig/8.0 bar) exceeds the
rated capacity of the tool,
which will shorten tool life
through faster wear and
could cause injury.

LUBRICATION

Lubricate the air motor daily
with NAPA air tool oil. If no
air line oiler is used, run
1/2 oz. of oil through the
tool. The oil can be
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE ThIS mAN U AL fOR fUTURE REf ER ENCE.
6-1078
Always use clean, dry air.
Dust, corrosive fumes, and/
or water in the air line will
cause damage to the tool.
Drain the air tank daily.
Clean the air inlet filter
screen at least once per
week.
The air inlet used for
connecting the air supply has
standard 1/2" NPT American
Thread. Line pressure should
be increased to compensate
for unusually long air hoses
squirted into the tool air
inlet or into the hose at the
nearest con n ec t ion to the air
supply, then run the tool.
Overfilling will cause a
3
(over 25 feet). Minimum
hose diameter should be
1/2" I.D. Fittings should
have the same inside
dimensions and should
be tightly secured.
Ensure an accessible
emergency shut off valve
has been installed in the air
supply line and make others
aware of its location.
re d uc t ion in the power of
the tool.
Rev. 02/18/14