Care And Maintenance; Troubleshooting; Corrective Action - Litex C-ST52BNK5D1 Mode D'emploi

CARE AND MAINTENANCE

At least twice each year, lower canopy (B) to check downrod (A) assembly, and then tighten all
screws. Clean motor housing (D) with only a soft brush or lint-free cloth to avoid scratching the finish.
Clean blades (G) with a lint-free cloth. You may occasionally apply a light coat of furniture polish to
wood blades for added protection.
IMPORTANT: Shut off main power supply before beginning any maintenance. Do not use water or a
damp cloth to clean the ceiling fan.
• Total wattage for this fixture is 18 watts; do not attempt to replace the LEDs.

TROUBLESHOOTING

WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not move.
Noisy operation.
Excessive wobbling.
Fan operates but
light fails.
NOTE: A small amount of "wobble" is normal and should not be considered a defect.
POSSIBLE CAUSE
1. Power is off or fuse is blown.
2. Faulty wire connection.
1. Blades are loose.
2. Cracked blade.
3. Fan is new.
1. Blades are loose.
2. Unbalanced blades.
3. Fan not securely mounted.
4. Fan too close to vaulted ceiling.
5. Set screw(s) on motor housing yoke
is (are) not tightened properly.
1. Wires in outlet box not wired
properly.
2. Wall switch to fan is off.

CORRECTIVE ACTION

1. Turn power on or check fuse.
2. Turn power off. Loosen canopy
and check all connections.
1. Tighten all blade screws.
2. Replace blade.
3. Allow fan a "break in" period of a
few days, especially when
running the fan at Medium and
High speeds.
1. Tighten all blade screws.
2. Switch one blade with a blade
from the opposite side or use
balancing kit (K).
3. Turn power off. Carefully loosen
canopy and verify mounting
bracket is secure.
4. Use a longer downrod or move
fan to another location.
5. Tighten yoke set screw(s)
securely.
1. Check wires in outlet box and, if
necessary, re-wire according to
instructions on pages 10 - 11.
2. Make sure wall switch to fan is on.
16