Litex C-ST52BNK5D1 Mode D'emploi page 13

FINAL INSTALLATION
3.
Locate LED light kit screw (L) from LED light kit (U)
(on underside of motor housing (D)) with a red dot
beside it; remove this LED light kit screw (L) from
LED light kit (U). Partially loosen the other LED light
kit screws (L). Align slotted holes in center of fitter
plate (M) with loosened LED ligt kit screws (L). Twist
fitter plate (M) to lock. Re-insert LED light kit screw
(L) that was removed and secure all LED light kit
screws (L).
Remove finial (Q), finial plate (P) and hex nut (O)
4.
from threaded rod (N). Save all for later use.
Attach threaded rod (N) to motor housing (D),
ensuring it is completely secure.
5. Align hole in center of glass shade (J) with
threaded rod (N), allowing pull chains to come
through corresponding holes in glass shade (J).
Push up gently on glass shade (J) until threaded
rod comes through hole, then secure with hex
nut (O).
Align hole in center of finial plate (P) with
threaded rod, allowing the pull chains to come
through appropriate holes in finial plate (P) and
push up. Secure glass shade (J) by tightening
finial (Q).
CAUTION: Do NOT overtighten hex nut (O)
as glass may crack or break.
3
D
L
U
4
D D
O
O
P
Q
5
D
O
P
13
Red
Dot
L
M
L
N
N
J
Q