Summit CR2B22ST Mode D'emploi page 10

2. 4-Wire Power Cord Installation
IMPORTANT: Use the 4-wire cable from power supply where local codes do not permit connecting the
frame-ground conductor to the neutral (white) junction box wire.
1. Disconnect power
2. Remove junction box cover if present.
3. Connect the flexible cable conduit (3) from the
cooktop to the junction box (4) using a UL listed
or CSA approved conduit connector (7).
4. Tighten screws on conduit connector, if present.
5. Connect the two black wires (1) together using
the UL listed wire nut (5).
6. Connect the two red wires (2) together using
the UL listed wire nut.
7. Connect the green wire (6) from the cooktop
cable to the green wire (6) (in the junction box)
using the UL listed wire nut.
8. Put a UL listed wire nut on the end of the white wire (8).
NOTE: Do not connect the bare ground wire to the neutral (white) wire in the junction box.
9. Install junction box cover.
10. Reconnect power.
9