Lan Connection Socket; Power Supply; Input Switch (Contact); Output Switch (12 V, Relay) - Telecom Behnke B-Smart Instructions

Instructions B-Smart
GB
Introduction

LAN connection socket

Usually, an RJ-45 connector is used to establish
LAN connection. When operated with the series
20 IP basic electronics, the network connection
can also be established via the series 20 IP
basic electronics. To do so, connect the camera
module's RJ-45 socket to the Series 20 basic
electronics's socket marked "Port2" using a
patch cable. Power for the camera will then be
supplied via PoE from the IP basic electronics.

Power supply

Power for the Behnke IP camera is supplied via
the ethernet port (PoE).

Input switch (contact)

A potential-free contact triggers this input
switch (e.g. relay 2 of the a/b connected door
intercom). This switch is triggered during a call
and turns on the camera. When used with an IP
door intercom, this is only necessary for using
the B-Smart App functionality.
39

Output switch (12 V, relay)

Use the web front end to activate this switch.
Together with the Behnke IP video software or
the "TC Behnke" app the output switch may
hold the open door function. To do so, connect
the output switch to Behnke door intercom's
alarm input. It is also possible to enable the
relay together with the Behnke door intercom's
relay holding the open door function. In stand
alone mode, the relay may directly enable the
open door function.
www.behnke-online.com