Appliance Protection; Maintenance And Care; Warranty; Customer Service Centre - Atrium genio Automotive 10.052.9 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
will be switched off. The appliance will then be in the
setting mode once again.
In the event that the main switch is released (before
reaching the set torque) during clockwise rotation,
please once again loosen the screw completely and
continue with the screw process from the beginning.
After tightening the screw connections, they are to be
inspected for visual damage.
Attention: After tightening safety-relevant screws /
nuts (e.g. wheel nuts on a vehicle), these screws
must be re-tightened to the described torque level
with a torque wrench in accordance with the details
of the respective vehicle manufacturer and then in-
spected.
This appliance is only intended for short-term use. Please do
not use this appliance for periods amounting to more than 3
minutes. The appliance automatically switches off in the event
of overloading and can only be used again after an appropriate
cooling period. Please adhere to this cooling period in order
to prevent damage to the appliance.

Appliance protection

Low voltage recognition
After 2,5 seconds, low voltage (threshold – approx. 8.5
V). The letters „BAT" will be displayed. All user entries
will be deactivated.
The low voltage situation will be removed in the event that
the voltage is above the limit for a period of at least 3
seconds.

Maintenance and care

Do not use any solvents to clean plastic parts as the
solvents can corrode and damage the plastic.
Only use dry, clean cloths in order to remove dirt, dust,
oil, grease, etc.
Please observe the legal regulation when disposing of the
electrical impact wrench.

Warranty

In line with statutory regulations this appliance has a 24
month warranty, starting from the date of purchase. A copy
of the sales receipt is sufficient proof in the event of a claim
subject to warranty. Damage due to regular wear, transport,
overloading, failure to observe the instructions of assembly /
operation or the improper handling are not covered by the
warranty. The same applies to wear parts. The manufacturer is
not liable for indirect consequences and damage to property.
The period of warranty is not renewed or extended following
possible repairs. Claims under warranty are only recognised if
the complete appliance is sent, shipping paid, to the manufac-
turer, the distributor or the services centre listed below.

Customer service centre

If it is not possible to return the appliance to the supplier in
the event of a claim subject to warranty, a failure of the appli-
ance or if a spare part is required, please refer to the following
address:
Atrium Enterprises GmbH
Zum Pier 72
D-44536 Luenen
Germany
Tel.: +49 - (0)2 31 / 8 09 01-0
Fax: +49 - (0)2 31 / 8 09 01-1 11
E-Mail: service@atrium-enterprises.de
GB
11

Publicité

Table des Matières
loading

Table des Matières