Installation Of The Appliance; Electrical Connections; Power Consumption - Lovibond ET 618-4 Mode D'emploi

3.4. Installation of the appliance

When chosing a location for the appliance the following points should be taken into
account:
The floor of the working area should be flat and level. Any uneveness can be compen-
sated with the aid of the two adjusting feet (wrench size 22 mm).
The rear side of the appliance may be placed directly against the wall. The convection
grids on the rear side of the appliance are not to be covered (e.g. table tops etc).
The carrying capacity of the retractable grids are about 45 kg.
Overall dimensions of the appliances in mm:
ET 618-4
ET 619-4
ET 626-5
ET 627-5
ET 636-6
ET 637-6
ET 650-8
ET 651-8

3.5. Electrical connections

Connect the power cord to a shock-proof wall outlet. Any repositioning of the wall
outlet may only be undertaken by a trained specialist. The VDE recommendations must
be observed.
The socket must be protected with a fuse of at least 10 amps, which must not be in
the rear section of the unit and must be easily accessible.
ET 618-4
ET 619-4
ET 626-5
ET 627-5
ET 636-6
ET 637-6
ET 650-8
ET 651-8
Prior to putting the thermostat-controlled incubator into operation we recommend a tho-
rough inner and outer cleaning of the appliance (see paragraph "cleaning" on page 23).
Thermostatschränke • Incubators • Etuves réfrigérées
Armarios termostaticos • Estufas reguladas por termóstato_9 07/2013
• no direct exposure to sunlight
• no proximity to any form of heating
• well ventilated rooms
Height Width
850 600
885 600
1216 600
1216 600
1590 600
1590 600
1516 752
1516 752
Line voltage

Power consumption

230V/50Hz
230V/50Hz
230V/50Hz
230V/50Hz
230V/50Hz
230V/50Hz
230V/50Hz
230V/50Hz
Depth
600
600
600
600
600
600
710
710
200 VA
210 VA
230 VA
240 VA
230 VA
240 VA
230 VA
240 VA
17