General Notes; Operation; Batteries; Measuring Weight Only - Beurer BG 13 Mode D'emploi

• Never expose batteries to direct sunlight or rain.
• Remove batteries from the device if it is not used for a long period of time.
• Dispose of discharged batteries immediately and properly. Never dispose of batteries in fire.
• When disposing of batteries, keep batteries with different electrochemical systems separate.

4.2 General notes

• Please note that measuring tolerances are possible due to technical reasons because the scale has not been
calibrated.
• Ages 10 to 100 years and height settings from 100 to 220 cm (3-03" to 7-03") can be preset. Load capacity: max.
150 kg (330 lb, 24 st). Result in steps of 100g (0.2 lb, 1/4 st). Measurements of body fat, body water and muscle
density in steps of 0.1%.
• When supplied to the customer, the scale is set to weigh and measure in "kg" and "cm".
On the back of the scale, there is a toggle button where you can select "pounds" (lb) and "stones" (st).
• Place the scale on a firm level floor; a firm floor covering is required for correct measurement.
• The scale should be cleaned occasionally with a damp cloth. Do not use abrasive detergents and never immerse
the scale in water.
• Protect the scale against hard knocks, moisture, dust, chemicals, major temperature fluctuations and heat
sources which are too close (stove, heating radiator).
• Repairs may only be carried out by customer service or authorized dealers. Before submitting any complaint,
first check the batteries and replace them if necessary.

5. Operation

5.1 Batteries

If present, pull the battery insulating strip off the battery compartment cover or remove the battery's protective film and
insert the battery according to the polarity. If the scale fails to operate, remove the battery completely and insert it again.
Your scale is equipped with a "replace battery" indicator. When the scale is operated with a battery which is too weak,
"Lo" appears in the display field and the scale automatically switches off. In this case the batteries must be replaced
(1 x 3 V lithium battery CR2032).

5.2 Measuring weight only

Step onto the scale. Stand still with your weight distributed equally on both feet. The scale begins to take measure-
ments straight away. If the display appears continuously, the measurement has finished.
If you step off the weighing area, the scale switches off after a few seconds.

5.3 Setting user data

To measure your body fat percentage and other physical data, you must enter your personal user para meters.
The scale has 10 memory positions in which you and other members of your family can save and recall personal
settings. Please note that the memory begins with 1.
Switch on the scale (tap the standing surface). Wait until the display shows "0.0".
Then press "SET". The first memory position will appear flashing on the display. Now you can enter the following
settings:
Memory position
Age
Body size
Sex
Degree of activity
– Changing the values: Press button
– Confirming the entries: Press the "SET" button.
The values that you have set here are then displayed again one after another. The scale then switches itself off
automatically at this point.
1 to 10
10 to 100 years
100 to 220 cm (3'-03" to 7'-03")
male ( ), female ( )
1 to 5
or .
13