Connecting The Drive To Your Computer; Dismount And Disconnect The Drive - Toshiba CANVIO PREMIUM Manuel De L'utilisateur

Connecting the drive to your
computer
1. USB 3.0 Micro-B connector
2. USB 3.0 Standard-A connector
1. With your computer powered on and fully booted up, plug the USB 3.0
Standard-A connector into a USB port of your host system, or an active
USB HUB.
You may need USB 3.0 Express Card Host Controller for your computer if
NOTE the computer doesn't have USB 3.0 port. You also can connect the device
to USB 2.0 port of your computer, However the transfer rate will be
downgraded to that of USB 2.0.
2. Now, plug the USB 3.0 micro-B connector into the corresponding port of
the drive itself.
Immediately,
■
■
■

Dismount and disconnect the drive

It is strongly recommended not to unplug the drive by just unplugging the
cable connection as it may be that data is written to the drive at that time.
Such data will be lost and the drive may be damaged physically!
User's Manual
1
the Power/Data indicator light will illuminate
the drive will power up
the drive should mount and a new drive icon should appear in "My
Computer"
CANVIO PREMIUM
2 3
3. USB 3.0 host
backward compatible to USB 2.0
EN-5