How To Assemble - Sammic LL-60 Mode D'emploi

HOW TO ASSEMBLE

STEP 1. TOP SET ASSEMBLY
• Wash the parts before first use.
• Ensure that the compression silicone and silicone ring are assembled
properly.
1. Firmly insert the compression silicone into the slot below the pulp spout.
Note: the Juicer may leak if not assembled properly.
2. Place the juicing screw into the strainer. Turn and press down on it until
it clicks in place.
Note: the juicing screw needs to be locked in place in order to close
the drum lid.
3. Assemble the strainer into the rotation wiper then place this assembly into
the juicing blow ensuring the red dot on the strainer is aligned with the red
dot on the juicing bowl.
4. Place the drum lid on to the juicing bowl aligning the red dot on the drum
lid with the red dot on the juicing bowl.
STEP 2. TOP SET AND BASE ASSEMBLY
TIP: for easy assembly hold the drum lid by grabbing the feeding tube and
turn clockwise as shown in the illustration.
6. Open/ Close mark on the top-set.
10
EN