LG DLEY1701 E Serie Manuel Du Propriétaire page 15

CAUTION
Do NOT remove any of the eight screws on the
face of the cabinet (marked below). Doing so
could result in damage to the dryer and the need
for a service call to repair the dryer.
e. Remove the three screws on the hinge at the
bottom left. Remove the hinge and reinstall it
on the right side. The top screw will occupy
the hole where you removed the screw behind
the hinge bracket in step d.
f. Install the hinge bracket removed in step d on
the bottom left side, first installing one screw
behind the hinge bracket.
ON THE DOOR:
4
Lift off the door cover.
With the door laid inside facing up on a protected
surface, remove the twelve screws on the inside
of the door. Carefully lift off the door cover with
the help of a small flat blade screwdriver inserted
in the upper corner (circled below).
WARNINg
The edges of the door cover may be sharp. Take
care when handling, or wear gloves to avoid
injury.
Twelve screws
Hole
plug
Interlock
button
5
Switch the door strike and the blank cover.
Remove the four screws on the door cover that
secure the door strike and the blank cover.
Switch the door strike and the blank cover,
installing them on the opposite sides from which
they were removed.
Long
screws
screw
Blank cover
Gently pry out the hole plug on the side of
the door cover and install it in the hole on the
opposite side.
Set the door cover aside.
INSTALLATION
Short
Long
screw
Door strike
Hole
plug
15