Warnings, Safety Information And Guidance - Titon auramode HRV Manuel Produit

EN

Warnings, Safety Information and Guidance

Important Information Read instructions fully before the installing this appliance.
1. This manual covers the operation of the HRV control system only, it
must therefore be read in conjunction with the relevant heat recovery
unit Product Manual.
2. Installation of the appliance and accessories must be carried out by a
qualified and suitable competent person and be carried out in clean,
dry conditions where dust and humidity are at minimal levels.
3. All wiring must conform to current I.E.E. Wiring Regulations and all
applicable standards and Building Regulations.
4. auramode must be connected using the communication cable provid-
ed.
5. Control & communication cables should not be placed within 50mm
or on the same metal cable tray as any 230V lighting or power cables.
6. Ensure all cable glands are fully tightened.
7. The unit must be stored in a clean and dry environment. Do not install
the appliance in areas where the following may be present or occur;
• Excessive oil or a grease laden atmosphere,
• Corrosive or flammable gases, liquids or vapours,
• Ambient temperatures above 40°C or below -5°C,
• Humidity levels above 90% or is a wet environment.
8. The appliance is not suitable for installation to the exterior of the
dwelling.
9. This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervi-
sion or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
10. Children should be supervised to ensure that they do not play with
the appliance.
11. To ensure compliance with the requirements Building Regulations
Approved document Part F use of the default schedule is not recom-
mended. The schedule should be cleared in the Scheduler section of
the menu.
4