SAMES KREMLIN 107 333 Notice Originale page 9

ADJUSTMENT - DISASSEMBLY / ASSEMBLY

INDEXING ADJUSTMENT
Install the nozzle (41) into the gun aircap.
Place the locating ring (15) on the nozzle.
Make the whole turn to get a correct locating of the nozzle.
Install the spring (14), the nozzle nut (13) and the index dial (36).
Note the number of the dial located in front of the marking ()
done on the aircap (12).
It enables to find again the correct position after cleaning or
changing the nozzle.

DISASSEMBLY / ASSEMBLY OF THE GUN
Stop the installation (Depressurize, drain, disconnect).
Disconnect the heated unit plug.
Disconnect the fluid hose.
Separate the heated gun assembly from its support.
Install a new heated gun or remove the inlet unit from the gun, the heated unit and change the bare
gun.
Install the parts.
Start again the installation.

CHANGING THE GUN SEALS
Unscrew the 4 screws (37) to separate the rear stop (33) from the body (26).
Take off the spring (31), the nut (30) and the washer (29).
Remove the nozzle nut (13), then unscrew the 2 screws (39) to separate the aircap from the gun
body.
Unscrew the needle rod (19) from the needle (18).
Unscrew the wetting cup nut (24) and take off the rod guide (23).
Take off the seals (21) and the 2 washers (20 & 22).
Change the seals (21) and the 2 washers (20 & 22).
Reinstall the rod guide, then screw slightly the wetting cup nut
Reinstall the other parts changing the seals with new seals.
Supply the gun with fluid, then tighten the wetting cup to ensure the fluid tightening.
SAMES KREMLIN 8

Doc. / Dok. : 574.334.110
12
41
15
14
13
36