Aqua Marina TOMAHAWK Mode D'emploi page 8

C
SEAT INSTALLATION
1. Attach the seat to the kayak/canoe floor with Velcro. It is important to place the
seat in the right place to evenly balance the boat when in the water. A solo
paddler should be slightly aft of the boat's center. With two paddlers, the
heavier one should sit toward the rear.
2. Once seat position is confirmed, connect the seat straps to the D-rings by using
seat strap buckles. Attach the upper straps to the D-rings forward of each seat.
FOR 2 USERS
FOR 3 USERS
NOTE: AIR-C is designed for 2-3 users. Seat position could be easily adjusted by
clipping strap buckles to different D-rings, and strap buckles may be clipped to
the same D-ring if needed. Please refer to above seat position layout for reference
when there are 2 or 3 users.
D
KAYAK FIN INSTALLATION
Turn the kayak/canoe over and slide the kayak fin into the fin box. It only slides in
facing one way. Slide in the push-in pin into the groove until it clicks into the position.
8