Singer ESP2 Manuel D'instructions page 9

4. Place a damp cloth over the fabric before pressing, which will help with stubborn
wrinkles or heavy gauge fabrics.
5. To press large pieces of fabric, place entire piece behind the Ironing Board. Pull the
fabric towards you, over the Ironing Board, and lower the Pressing Plate. Press the
fabric in sections until completed.
Using the Pressing Cushion
1. For garments constructed with details such as darts, curved seams, and shoulder
pads, a Pressing Cushion may be used.
2. Use the cushion in areas where no creases are desired
or to shape a tailored garment.
3. Place the area to be pressed onto the Ironing Board.
4. Place the Pressing Cushion under the dart, seam, etc.
5. Making sure that the area to be pressed is raised,
lower the Pressing Plate until it meets the raised area.
6.Do not force the plate to its lowest position, as this may
cause damage to the unit.
CLEANING THE STEAM PRESS & STORAGE
CLEANING THE STEAM PRESS
1. Place the Pressing Cushion in the middle of Ironing Board.
2. Place a clean towel over the Pressing Cushion and the Ironing Board.
3. Set the temperature control Button to its highest setting(LINEN).
4. When the Steam Burst Ready Indicator Light illuminates, lower Pressing Plate onto the
pressing cushion.
5. Press the steam burst button six times.
6. Allow the Pressing Plate to cool.
7. Clean the pressing plate with a damp cloth.
8. Do not use abrasives or you may damage the plate.
9. The Ironing Board cover is removable for cleaning. Hand wash only with mild
detergent.
STORAGE
1. Once pressing is complete, immediately turn unit off and unplug power cord from
electrical outlet.
2. Allow unit to cool completely(at least 30 minutes).
3. Lower pressing plate down;and turn Locking Knob to "Lock"position.
4. Wrap up power cord and place in Cord Storage Compartment.
5. Store all accessories safely away, preferably near Digital Fabric Steam Press.
6. Store Digital Fabric Steam Press in a cool, dry place.
7. For long-term of storage, press the steam button time to time, to use up the water
remain in the water reservoir.
struction Manual.indd 7
7
23.12.2011 15:25