Power Up - Oki C3600n Guide D'installation

Load the paper (maximum 250 sheets
4
2
20-lb. [80 g/m ] paper).
Make sure the paper width stoppers
5
are snug against the paper and are
locked in place.
NOTE: Do not fill above paper full indicator (A).
A
Gently close the paper tray.
6
Install the Handy Reference
Guide
Remove the backing from the
strip on the back of the Handy Reference
Guide and mount it on the side of the
printer.

Power Up

Insert the power cable (be sure to use
only the power cable supplied with
your printer), then plug it directly into a
grounded wall outlet and turn on the
printer. Do not connect the USB or
network cable at this time.
Alarm at power on?
If an alarm (amber light) displays on the
printer, do the following:
Make sure paper is loaded in the
1
printer.
Turn the printer off and on again.
2
Make sure the toner lock levers are in
3
the locked position. See step 4 "Install
Image Drum/Toner Cartridges" on
page 4.
®
VELCRO
Reinstall the drum/toner units. Make
4
sure the toner lock levers are in the
locked position.
If the alarm does not clear, complete the
steps to install the printer software.
When the software is installed, open the
status monitor for an explanation of the
alarm.
C3600n Setup Guide
6