Tools Needed For Assembly - peerless-AV PRG-UNV Instructions D'installation Et De Montage

NOTE: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions
and warnings contained in this Installation Sheet. If you have any questions regarding any of the
instructions or warnings, for US customers please call Peerless customer care at
1-800-865-2112, for all international customers, please contact your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience
with basic building construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and
all attached hardware and components.
• Never exceed the Maximum UL Load Capacity. See page one.
• If mounting to wood joists ceilings, make sure that mounting screws are anchored into the center
of the studs. Use of an "edge to edge" stud fi nder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly
reducing their holding power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product
failure and personal injury.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
• Wood Stud
• Wood Joist
• Solid Concrete
• Brick
• Other or unsure?

Tools Needed for Assembly

• stud fi nder ("edge to edge" stud fi nder is recommended)
• phillips screwdriver
• drill
• 5/16" bit for solid concrete surface
• 5/32" bit for wood studs
• open end wrench
• level
Table of Contents
Parts List................................................................................................................................................ 3
Projector Mount Assembly Installation................................................................................................4-7
Attaching Adapter Plate to Projector...................................................................................................... 9
Accessories ................................................................................................................................... 15, 16
WARNING
HARDWARE REQUIRED
Included
Included
Included
Contact Qualifi ed Professional (Not Evaluated By UL)
Contact Qualifi ed Professional
2 of 51
ISSUED: 09-30-09 SHEET #: 056-9024-6 08-26-14