Klarstein ILONA BRILLIANT EDITION Mode D'emploi page 24

EN
24
Fix the outside chimney bracket on the outside chimney with 2 screws (ST 4*8 mm),
and be sure that the inside chimney can be adjusted the height in it freely.
Afterwards, install chimneys on the cooker hood. Lay the expansion pipe to the wall
outlet. Fix the expansion pipe with the cable tie on the wall-outlet (see figure 3).
Inside chimney
Outside chimney bracket
Outside chimney
3. Adjust the height of the inside
chimney to the position of the
inside chimney bracket and fix
on it by 2 screws (ST 4*8 mm).
After adjusting the position, fix the
body with safety screw (see figure
3 and 4).
Note: The two safety vents with a diameter of 6 mm are positioned on the back
housing.
Figure 3
Figure 4