Beko WMD 77140 Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6 Solution suggestions for problems
Problem
Cause
Machine may have switched
Program cannot
to self protection mode due to
be started or
an infrastructure problem (such
selected.
as line voltage, water pressure,
etc.).
There is water
coming from the
There might be problems with
bottom of the
hoses or the pump filter.
machine.
Machine stopped
Machine can stop temporarily
shortly after the
due to low voltage.
program started.
It continuously
spins.
There may be an imbalance of
Remaining time
laundry in the machine.
does not count
down.
In the case of a paused
countdown while taking in
water:
Timer will not countdown until
the machine is filled with the
correct amount of water.
In the case of a paused
countdown at the heating step:
It continuously
Time will not count down until
washes.
the selected temperature for
Remaining time
the program is reached
does not count
down.
In the case of a paused
countdown at the spinning
step:
There may be an imbalance of
laundry in the machine.
Explanation / Suggestion
Reset your machine by pressing "Start/Pause/
Cancel" button for 3 seconds. (see, Canceling a
Program)
Be sure the seals of the water inlet hoses are
securely fitted.
Tightly attach the drain hose to the tap.
Make sure that the pump filter is completely closed.
It will resume operating when the voltage is back to
the normal level.
The automatic spin correction system might have
been activated due to the unbalanced distribution of
the laundry in the drum.
The laundry in the drum may be clustered (bundled
laundry in a bag). Laundry should be rearranged and
re-spun.
No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
The machine will wait until there is a sufficient
amount of water to avoid poor washing results due
to lack of water. Then the timer will start to count
down.
The automatic spin correction system might have
been activated due to the unbalanced distribution of
the laundry in the drum.
The laundry in the drum may be clustered (bundled
laundry in a bag). Laundry should be rearranged and
re-spun.
No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
11 - EN

Publicité

Table des Matières
loading

Table des Matières