Warm Tech TC2104TVTIM Traduction Des Instructions D'origine page 11

GB CONVECTOR HEATER WITH THERMOSTAT
This guide is intended to help you install and care for your fan heater.
Please read all documentation carefully before installing and using your heater.
Make sure that the air inlet and outlet openings are not blocked. To avoid any risk of fire, do
NOTICES
 Please read these instructions carefully
before using the heater and keep the booklet
for future consultation.
 This heater must only be used for heating
homes and similar environments, in
conformity with these instructions; it is to be
considered as a supplementary heating
device and not as a central heating system.
 The fan heater gets hot when working; so
only touch the handle and plastic Knobs.
Avoid contact with the heating element.
 Do not cover the heater to avoid the risk of
fire.
 Make sure that the fan heater is not in
contact with water or other liquids.
 Do not touch the heater with wet hands or
feet.
 Do not allow the heater to be used by
children or other irresponsible persons
without supervision.
 Do not expose the heater to the weather
(sun, rain, etc.)
 Do not pull on the power cord or the heater
to unplug the heater from the electric socket.
not cover the heater (ex. With clothes)
Warning / Danger!
In accordance with
essential applicable
safety standards of
European directives
INSTALLATION
After removing the packing materials, check
the integrity of the heater; if you are unsure,
 do not use it and ask for qualified
professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.)
must be kept out the reach of children
because they are potential sources of
danger.
 Before connecting the appliance, check that
the voltage shown on the data plate matches
that of your electricity and that the electric
plug is grounded. In the event of
incompatibility between the electric outlet
and the plug of the heater, have the outlet
replaced with another more suitable type by
professionally qualified personnel, who will
make sure that the section of the wires of the
outlet is appropriate for the absorbed power
of the heater (10A). In general, the use of
adapters or extension cords is not
recommended; if their use is indispensable,
they must conform to existing safety
standards and their current capacity
(amperes) must not be less that the
maximum of the heater.
 Before each use, verify that the heater is in
good condition and that the electrical cord is
not damaged: in the case of doubt, ask for
professionally qualified help.
11