Thermador WDC30J Manuel D'installation page 11

Attach Custom Drawer Front
Pilot Holes
4x Pilot holes
7/16"
(11 mm)
Figure 8: Drilling the Pilot Holes
1. On the back side of the custom front panel,
mark the pilot holes at the locations and
specifications indicated in Figure 7 and
Figure 8.
2. Drill pilot holes. BE CAREFUL NOT TO
DRILL ALL THE WAY THROUGH THE
CUSTOM FRONT PANEL! Pilot holes should
only be 7/16" (11 mm) deep.
3. With the flanges facing away from the custom
front panel, screw the included stainless steel
panel to the back of the custom front panel
with four (4) 1/2" (12.7 mm) screws. Do not
tighten down.
4. Line the widest part of the keyholes at the front
of the warming drawer with the screws of the
panel assembly. Push the panel assembly into
the keyholes so that it is flush with the
warming drawer front, then carefully slide the
panel assembly down so that the screw heads
slip into the narrow part of the keyhole.
5. Secure the screws through the backside of the
brackets.
Figure 9: Custom Front Panel Installation
dia. 3/32"
(2.5 mm)
English 9