Custom Drawer Front - Thermador WDC30J Manuel D'installation

Custom Drawer Front

WDC30J
Specifications and Dimensions
WDC30J
Product Width 29½" (749 mm)
Product Height 10½" (267 mm)
Product Depth 22" (559 mm)
Cutout Width 28½" (724 mm)
Cutout Height 10" (254 mm)
Cutout Depth 23" (584 mm)
Minimum 29 ¾" (756 mm)
Front Panel Width 11¼" (286 mm)
Front Panel Height
Front Panel Depth
Clearance for door
opening plus custom panel & handle depth
Electrical Supply 120 V AC, 60Hz
Circuit Breaker
Wattage
Power Cord Incl. 120V-3-Wire
Cord Length 72" (1,829 mm)
Shipping Weight 65 lbs (30 kg)
B
C
English 8
WDC36J
WDC36J
35½" (902 mm)
10½" (267 mm)
22" (559 mm)
34½" (876 mm)
10" (254 mm)
23" (584 mm)
35 11 " (907 mm)
/
16
11¼" (286 mm)
¾" (19 mm)
¾" (19 mm)
18¾" (476 mm)
120 V AC, 60Hz
15 Amp 15 Amp
930 1080
120V-3-Wire
72" (1,829 mm)
75 lbs (34 kg)
Custom Panel Rear View
A A A
C
L
Custom panels must meet the following
requirements:
• Have a handle.
• Have a minimum thickness of ¾" (19 mm).
• Have all edges finished.
• If using wood, the back must be sealed to prevent
moisture damage.
• Be capable of withstanding temperatures above 158°F
(70°C).
Custom Drawer Front Preparation
1. Mark pilot holes on the back side of the panel
according to the dimensions indicated in Figure 7.
2. Drill pilot holes with a 3/32" (2.5 mm) drill bit. Be
careful not to drill all the way through the panel.
Pilot holes should only be 7/16" (11 mm) deep, see
Figure 8 on page 9.
3. Attach your own handle.
B
C
D
Dimension WDC30J
A 22" (559 mm)
B 2½" (64 mm)
C 13
1 " (46 mm)
/
16
D 5
12 " (313 mm)
/
16
Dimension WDC36J
A 28" (711 mm)
B 2½" (64 mm)
C 13
1 " (46 mm)
/
16
D
5
15 " (389 mm)
/
16
Figure 7: Pilot Holes Hole Dimensions