EtiamPro HAA52N Mode D'emploi page 6

5.2
Loosen the screw on the bottom of the box to release the front
cover from the rear cover.
5.3
It is necessary to remove the PCB before mounting the rear cover.
Loosen the PCB fixing screw. Pull out the PCB carefully.
5.4
The rear cover is prepared for either surface or corner mounting,
or mounting with the supplied swivel bracket.
•
•
Refer to the illustrations on page 2 of this manual.
5.5
•
•
•
6. Walk Test
•
•
V. 03 – 08/06/2020
Front Cover Removal
PCB Removal
Rear Cover Mounting
Punch the cable hole at the back of the rear cover, together
with the fixing holes (knockout holes) according to the
mounting (surface or corner mounting, or mounting with the
supplied swivel bracket).
Mount the rear cover or mount the swivel bracket with
screws (mount the rear cover on the swivel bracket
afterwards).
1 rear cover
2 fixing screw
Wiring and Finishing
Fix the PCB back onto the rear cover.
Connect the wiring to the terminal block.
Place the front cover onto the rear cover and fix with the
screw. Make sure you hear the tamper switch clicking. Align
the detector.
Walk test can be performed after the power-up display
expired - the alarm LED is flashing during the power-up
period - to test the detector over the entire protected area
to verify proper operation of the unit.
Walk into the protected area at a rate of one step per
second across the protection beams and observe the LED.
HAA52N
6
3 swivel bracket
©Velleman nv