Removing The Mcs Ii System From The Helmet - N-Com MCS II Mode D'emploi

3.1.

Removing the MCS II system from the helmet

Proceed as follows to remove the MCS II system from the helmet:
Remove the cheek padding and the shell gasket;

Completely remove the MCS II system from the helmet and re-install the cheek

padding and the gasket.
Fig. 8
Fig. 9
If

extension
positioned behind the
comfort cheek pad.
WARNING:
carefully check that the
extension cable does not
prevent the correct sliding
of the
mechanism.
Unhook the right clip from the shell,

levering upward using a flat head
screw (or a similar tool), as shown
in figure 9.
not used, the
can be
Please
VPS inner visor
13