Installation Codes And Standards - Vulcan HGB Serie Mode D'installation Et Mode D'emploi

Before installing, verify that the type of gas (natural or propane) agrees with the specifications on the
data plate located behind the lower front cover, riveted to the center support of the burner box bottom
(HGB models), or between the grease pan guides, riveted to the left corner of the lower front cover
(GHCB models). Be sure the unit is built for the installation elevation.
UNPACKING
The charbroiler was carefully inspected before leaving the factory. The transportation company
assumes full responsibility for safe delivery upon acceptance of the shipment. Immediately after
unpacking, check for possible shipping damage. If the charbroiler is found to be damaged after
unpacking, save the packaging material and contact the carrier within 7 days of delivery.
Do not use the drawers or handles to lift or move the charbroiler.
LOCATION
The equipment area must be kept free and clear of combustible substances. A minimum 2" (51 mm) of
clearance to combustibles must be provided at the rear of all broilers; no side clearance is required for
combustibles or noncombustibles. The HGB(M) is to be installed only on noncombustible floors. The
GHCB is suitable for installation on combustible floors.
Install the charbroiler in an area that has sufficient air supply for combustion of the gas at the burners.
Provide adequate clearance for air openings into the combustion chamber. Do not obstruct the flow of
combustion and ventilation air.
Do not permit fans to blow directly at the charbroiler and, wherever possible, avoid open windows next
to the sides or back. Avoid wall-type fans that create air cross currents within the room.
Legs
Legs (6-inch [152 mm] stainless steel) or casters are factory assembled onto the bottom of the
charbroiler as specified on order.
Modular Broilers
Models HGB34M, HGB50M, HGB60M and HGB71M must be installed on a noncombustible, level
counter or stand. No adjustment is provided.
When a modular broiler is installed on a counter, it must be sealed to the counter with an NSF-approved
sealant.

INSTALLATION CODES AND STANDARDS

Install this equipment in accordance with:
In the United States
1. State and local codes, or in the absence of local codes, with:
2. National Fuel Gas Code, ANSI-Z223.1 (latest edition), available from The American Gas
Association, Inc., 1515 Wilson Boulevard, Arlington, VA 22209.
3. National Electrical Code ANSI/NFPA70 (latest edition) (if applicable).
INSTALLATION
– 4 –