Vulcan HGB Serie Mode D'installation Et Mode D'emploi page 8

WARNING: HOT PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING THE BROILER.
LIGHTING THE MANUAL GAS PILOT
Adjustment of the pilot light must be performed by a qualified Vulcan-Hart installation or service person.
The flame adjustment must be made at the time of installation.
1. Turn main gas supply ON.
2. Wait 30 seconds and, using a lighted taper, light the pilots. The pilot for each burner must be lit
(Fig. 4).
3. If pilot fails to light, turn main gas supply OFF. Wait 5 minutes and repeat.
Nightly Shutdown
Turn burner valves OFF; pilots will remain lit.
Complete Shutdown
1. Turn burner valves OFF.
2. Turn main gas supply OFF; pilots will go out.
OPERATION
Fig. 4
– 8 –