Operation Instructions - Muss Dental MA 31 Mode D'emploi

Am Weingarten 7 • D-30974 Wennigsen • Tel.: +49(0)5103 / 7065-0 • Fax +49(0)5103 / 7065-79
http://www.muss-dental.de • e-mail: muss.dental@t-online.de
O P E R A T I O N
GB
Foot Control Unit: MA 31
Technical Data
Max. Normal Output:
Rated Voltage:
Rated Frequency:
Noise Level:
Revolutions:
Handpiece:
Chuck:
Please read the instructions carefully before operating the unit, and keep it for later
use.
Warning!
The instructions are to be carefully read and followed to ensure proper operation and handling of the unit. Failure to do
so could result in serious injuries and/or damage to the unit.
These operation instructions are part of the unit.
-
Please keep it during the time the product lasts.
-
Please pass these operation instructions on to any successive possessor/user.
-
If other languages of these operation instructions may be needed, please contact the manufacturer. Any copying or
transmission of these operation instructions to a third party is prohibited without the specific approval of the
manufacturer.
The manufacturer cannot be held responsible for any damages resulting from:
- External interference (bad quality of the media or poor installation)
- Improper operation of unit
- Improper repairs
Interference by an unauthorised party would nullify any implied warranty. Muss Dental recommends using only new
authorised spare-parts for any repairs needed. As safe and proper operation of the unit can only be guaranteed by
correct use of the relevant burs, as outlined in the instructions.
Scope
The manufacturer's guidelines for the instruments need to be followed concerning the highest speed
allowance and the contact pressure (shaft of ø 2,35 or ø 3,0 mm). The highest speed allowance of
30.000 rpm may not be exceeded. Please only use rotating instruments from trade-marked
manufacturers and take care of the technical data, only the correct tools/burs need to be used by working
with a speed of 30.000 rpm.
Accident Prevention Regulations are to be followed!
The product needs to be kept indoor of normal room temperature and normal humidity and not to be
used in wet/humid rooms.
Primary function: for grinding purposes in the dental laboratories, only to be used by trained dental
technicians.
Goggles are always necessary when working with rotating instruments.
We advise you to use a dust aspirator or use a mask by working with plaster
Type F300 / H310
180 watt
230 volts / 2,5A/T
115 volts / 4A/T
50 / 60 Hz
53 dB(A)
1.000 - 30.000 rpm
brushless
Ø 2,35 mm or Ø 3,00 mm
I N S T R U C T I O N S
Order No.: 9527
Seite 9 von 19