Panasonic MULTI CF-VDM741U Instructions D'utilisation page 16

Using the Software
NOTE
DVD-Audio cannot be played back using WinDVD.
Do not start WinDVD while the hard disk drive indicator
after the computer is turned on.
While WinDVD is running, do not:
• Enter standby or hibernation.
• Switch the display by pressing Fn + F3 .
During video playback, do not:
• Eject the disc.
• Use other applications or the Command Prompt.
• Change the settings of the screen properties.
If you maximize the video display window, you can return to the original window
E
size by double-clicking over the images.
When the number of display colors is increased, a message appears and the DVD
cannot be played:
• Reduce the number of display colors.
• Right-click on the desktop, click [Properties] - [Settings] - [Advanced] -
[Troubleshoot] and maximize the value of Hardware acceleration.
Immediately after resuming from a pause, frame dropping may occur depending on
the operating environment or DVD-Video (images or sounds are disrupted).
In the Extended Desktop or simultaneous (internal/external) display mode, there are
times when images or video are not displayed correctly.
During a prolonged period of rapid advance, the pause mode may be established at
some point. If this happens, exit WinDVD, and restart.
Do not install another player software together with WinDVD.
Doing so may interfere with smooth playback. Some DVD-Video discs contain the
player software and start installing. In this case, cancel the installation as soon as pos-
sible. If you accidentally installed another player software and find a problem in play-
back, try either of the following procedures.
• Uninstall the player software by clicking [start] - [Control Panel] -
[Add or Remove Programs].
• Set WinDVD as the playback software if you can select the option in the player
software settings.
16
is blinking immediately