Turning On The Flat Panel Monitor; Adjusting The Viewing Position - Silicon Graphics 1600SW Guide D'utilisation

Tuck the power cable behind the clip on the rear of the stand.
Connect one end of the AC power cord to the AC adapter.
and the other end of the AC power cord to a grounded
electrical wall outlet or power strip. (The illustration shows
the AC adapter and cord for the U.S.A. The power cord for
your country may look different.)
Note: The AC adapter is auto-ranging, which means that it
automatically adjusts for different AC voltages from
almost any power source (50-60 Hz, 110-220 VAC)
without using an additional transformer.
Caution: Be sure to install your flat panel monitor close to a
grounded electrical wall outlet.

Turning On the Flat Panel Monitor

To turn on the monitor, press the power button on the front. See
Figure 1-1 for the location of the power button. Once the system
supplies signals to the flat panel monitor, the LED on the bottom left
turns green.
If the flat panel monitor does not light up, and if the LED is blinking
yellow, check that its interface cable is firmly attached to the correct
connector on the computer.
For additional troubleshooting information, go to Chapter 2,
"Troubleshooting."

Adjusting the Viewing Position

You can adjust the flat panel monitor to a height and tilt that is
comfortable for you. You can raise or lower the monitor a maximum
of 3.75 inches (95 mm).
Setting Up and Using the Flat Panel Monitor EN-5