Delayed Start; Keep Warm Function - Moulinex Steam'up Mode D'emploi

USE OF THE STEAM ACCESSORY
Use the steam accessory for vegetables and frozen ingredients and as you like.
• Before the first use of the Steam accessory, it is necessary to assemble all the parts which are
inside the bag in the accessory – fig. 49 to 59.
• Before first use, wash the accessory using warm water and washing-up liquid, rinse and dry.
• This accessory can be used inside heat-resistant container from 16cm to 28cm wide - fig. 61.
• Use an oven glove to carry and remove the steam accessory from the container - fig. 72.
• After use, wash the accessory using warm water and washing-up liquid, rinse and dry - fig. 73-74.

DELAYED START

Select the cooking mode or set the manual cooking settings before scheduling the delayed
start.
• Press the touchpad
• Select the delayed start time using the +/- buttons - fig. 77. When selecting the time you can
increase it by 15 minute periods and then by the hour.
• Press Start, and the delayed start timer will begin to count down. The appliance will
automatically start the cooking cycle when the delayed start timer reaches 00.
The delayed start time can be changed at any point.
DEFROSTING
• We advise you to use the Steam accessory (see Use of the Steam accessory section).
• Make sure the tank is full of water before starting the program.
• Select program P6
screen - fig. 79.
• Press key to launch the program - fig. 80.
• The automatic set time is 10 minutes. You can adjust this timing using +/- touchpads.

KEEP WARM FUNCTION

• Make sure the tank is full of water before starting the program.
• To activate « Keep warm » function, select program P8
appears. The symbol
• The automatic set time is 30 minutes. You can adjust this timing using +/- touchpads.
REHEATING
• Make sure the tank is full of water before starting the program.
• You can warm food by selecting P7 program
• Press key to launch the program.
• The automatic set time is 10 minutes. You can adjust this timing using +/- touchpads.
- fig. 76. The programming symbol
for Defrosting program by pressing Mode button until P6 appears on the
appears on the screen.
flashes on the screen.
by pressing Mode button until P8
.
EN
35