Stile Lancaster CF13650 Guide D'installation page 9

INSTALLATION
NOTICE:
The mounting bracket has a ceiling plate on the
upper surface to help keep the outlet box flush
with the sheetrock during bracket installation. To
allow you to better see some of the items being
discussed, the plate is not shown in some artwork.
This is for clarity purposes only. Do not remove the
ceiling plate from the mounting bracket.
INSTALLING THE CEILING FAN MOUNTING
BRACKET ASSEMBLY
 The mounting bracket assembly, canopy, and the canopy
screw cover ring are assembled together for shipping
purposes. If you haven't already done so, separate these
pieces now.
• Twist the canopy screw cover ring counterclockwise
to release.
• Loosen the two screws over the slots in the canopy.
• Remove the two screws and washers securing the
canopy to the mounting bracket assembly, then twist
the canopy counterclockwise to release from the other
two screws.
CEILING
PLATE
SCREW OVER
CANOPY SLOT
SCREW
WASHER
CANOPY SCREW
COVER RING
MOUNTING
CANOPY
BRACKET
WASHER
SCREW
SCREW OVER
CANOPY SLOT
 Remove any existing ceiling fan or light where you intend
to install this ceiling fan. Verify the existing outlet box is
marked acceptable for fan support up to 35 lbs. and that
it is securely fastened to the ceiling joists.
OUTLET
BOX
For Canada installations, refer to the Canada
Installation Addendum located in the Canada
Installation Hardware Bag and install the eye
bolt or anchor assembly now.
 Using the screws provided with the outlet box, attach the
ceiling mounting bracket assembly to the electrical box,
passing the 120V electrical supply wires through the hole
in the center of the mounting bracket assembly.
NOTE: If you are installing the mounting bracket assembly
for an angled orientation, make sure the open end of the
bracket is installed facing the lower point of the ceiling.
NOTICE:
Be careful not to overtighten the screws, causing
the outlet box to recess so it is no longer flush with
the sheetrock. Doing so will prevent the canopy
from aligning properly later in the installation
process.
9 - English
CEILING
MOUNTING
BRACKET
SCREW