Stile Lancaster CF13650 Guide D'installation page 8

INSTALLATION
 Insert the LED power lead into the socket on the light
panel. Make sure the connection is securely seated.
NOTE: Connector and socket are keyed to ensure correct
orientation.
LED POWER LEAD
 Flip the entire fan assembly right-side up to complete the
rest of the assembly process.
 Install a support arm by placing the tab of the arm into
the hole on the motor housing, then angle the arm up until
the nut is aligned with the threaded boss on the housing.
Lower the nut on the arm to cover the connection and
tighten securely. Repeat to install the remaining two arms.
NUT
SUPPORT
ARM
NUT
SOCKET
THREADED
BOSS
HOLE
TAB
8 - English
 Assemble the light shade by sliding the peg on one shade
panel into the square hole on the next panel, aligning the
screw holes. Insert a screw into each hole and tighten
securely. Repeat to attach the third panel.
NOTE: When completely assembled, the flange of each
panel will overlap the next. For the Lancaster fans only,
there is a retention tab on the diamond point where the
panels overlap. Pull the retension tab back before sliding
the two panels together, then reflatten the retension tab
against the panels.
SQUARE HOLE
PEG
SCREW
SCREW
SQUARE HOLE
 Set aside the completed shade until the fan is ready to
hang.
RETENSION
TAB
PEG
LIGHT SHADE
PANELS