Stile Lancaster CF13650 Guide D'installation page 15

INSTALLATION
 Place the receiver into the top of the mounting bracket
with the flat side facing the ceiling. Tuck the receiver an-
tenna and all wiring through the opening in the mounting
bracket and up into the electrical box, making sure the
wires don't become pinched.
SLIDES IN FROM THIS DIRECTION
 Connect the fan plugs at the end of the fan's electrical
wiring into their corresponding sockets on the receiver.
 Slide the canopy up into place and rotate clockwise to
lock to mounting bracket assembly. Reinstall the two
washers and screws (M4 x 6 mm) removed previously
and tighten securely.
TOP VIEW
MOUNTING
BRACKET
CANOPY
ANTENNA
MOUNTING
BRACKET
RECEIVER
TOP
CANOPY
SCREWS
AND
WASHERS
15 - English
NOTE: If the canopy won't align with the screw holes,
you may have overtightened the ceiling mounting bracket
screws when securing the bracket to the outlet box.
Remove the ceiling fan and loosen the screws just enough
to allow the outlet box to become flush with the sheetrock,
but not so much that the ceiling fan bracket is no longer
securely fastened to the outlet box.
 Lift the screw cover ring up over the screws and twist
counterclockwise to secure in place.
SCREWS
SCREW
COVER RING
 Remove the thumb nuts, gaskets, and washers at the
end of the support arms.
WASHER
GASKET
SCREWS
SUPPORT
ARM
THUMB NUT