Alarm Function; Installing Battery - Exotek Instruments MC-160SA Mode D'emploi

Pinless Moisture Meters
Manual
INTRODUCTION
With the MC-160SA moisture-measuring instrument, EXOTEK INSTRUMENTS
has introduced a hand-held moisture-measuring unit, incorpora ng electronic
circuitry perfected over years of development and prac cal applica ons with
the latest technology.
It is easy to determine moisture content in wood and building materials with
the contact measurement procedure without destroying the material. Reli-
ability, durability and a high standard of accuracy are assured by modern digital
components built to cope with the stress of everyday use.
The se ng of wood-groups and building material groups combined with an
automa c zero-correc on, allow more accurate measurements on all European
as well as Tropical mbers, as well as on a great number of building materials.
SWITCH-ON
By pressing this key once, if the device is off , the unit is
switched on.
SWITCH-OFF
By pressing this key once, if the device is on, the unit is
switched off .
Or: Automa cally a er approx. 30 seconds if the value does not change.

ALARM FUNCTION

The MC-160SA has the possibility to give an acous c
alarm in case of an user selectable alarm threshold is
reached or exceeded. This func on is most useful for
sor ng out mbers.
By pressing this key once the actual threshold value
(L06 – L36 or; L 0.3-L 4.0 or; 40-90% in RH mode) if the Building material group
E0 - E5 is selected) is indicated and the alarm func on is ac vated. In case this
key is pressed again, while the limit is indicated, the threshold value is being in-
creased by 1% moisture in the range of 6 – 36% or If the E0 - E5 is selected the
alarm threshold is increased with 0,1%. For RH mode the step increases by 1%
when the key is pressed). A er 2 sec. the unit is ready to take measurements.
To turn off the alarm func on press any other key.

INSTALLING BATTERY

• Open the ba ery lid on the backside of the meter.
• Install a 9 volt L6R22.
• Close the lid.
A low voltage is indicated with
the ba ery needs to be replaced. A new ba ery should be inserted to achieve
correct measuring results.
ENG
MC-160SA
at the upper le side of the display when
- 4 -