SKYTRONIC UBSF02-8 Manuel D'utilisation page 11

WARNING:
1.
Lay out the trampoline mat inside the frame.
2.
Connect 4 springs between the mat and the rail, at the 1/4 way points in the
circle, as in the figure below. Attach the rest of the springs according to the
steps outlined below.
Make sure the v-rings between the springs matches the number of holes in the
Note:
frame between the springs.
First connect the 4 springs
at the 1/4 points.
How To Use The Spring Pulling Tool
Step I: Hook the more rounded end of the spring
onto the trampoline mat's triangular rings.
Step II: Extend the spring pull tool and link it up
with the other end of the spring. Pull the tool in
the direction of the trampoline frame until the
spring head is lined up with the hole in the
trampoline frame.
Step III: Slide the spring end into the hole as
you remove the tool.
TRAMPOLINE MAT ASSEMBLY
Be careful where you place your hands during spring assembly as
connector points can pinch!
Follow by connecting
4 additional springs
in the center of the quarters.
Then continue,
connecting every
few springs
Complete the
rest of the springs