Bimar SPS-703 Notice D'instructions page 9

Fax +32 030 9904733
electrical appliances that incorporate a water reservoir: in the case of water overflows, immediately
remove the plug from the power outlet, make sure that the electrical components are not wet and, if
they are, carefully dry them completely. Make sure that the main switch is turned to "0" (off), put
the plug back into the outlet and then use the appliance. In the case of doubt, ask for professionally
qualified help.
D
•
o not remove the tank when the humidifier is on.
D
•
o not move the appliance when it is on and when the tank is full.
T
•
he tank can be removed only if it is turned off before the appliance and removed the plug from
the wall power outlet.
D
•
o not place your hands, face or body directly above the steam output orifice when the appliance
is on.
D
•
o not direct the steam jet at objects or walls.
U
•
nplug the appliance when not in use.
D
•
o not expose the heater to the weather (sun, rain, etc.).
D
•
o not touch the appliance with wet hands or feet.
• N
ever pull on the power cord to move the appliance.
N
•
ever pull on the power cord or the appliance to detach the plug from the power outlet.
I
•
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
Warning:
D
- o not use the humidifier without water. Only use demineralised or distilled water and
do not add any additives to the water (perfumes or essences). Should there be any
impurtities or dirt in the receptacle, rinse it carefully, allow it to drip-dry and place it
back in the appliance after having checked that the knob is in the "0" (off) position and
that it is not plugged into the socket.
T
- o diffuse aromas in the room, moisten only the extractible felt of the aroma dispenser
with a few drops of essential oils. Do not exceed the indicated quantities in order to
prevent damage to the surface and to avoid that the oil leaks to the inside of the
appliance.
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger; but dispose of them in accordance with current law.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity. In the event of incompatibility between the electric outlet and the plug of the
appliance, have the outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is appropriate for the
absorbed power of the appliance. In general, the use of adapters or extension cords is not
recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the appliance.
• Before each use, verify that the appliance is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9/36
Assembly page 9/36