Bimar SPS-703 Notice D'instructions page 11

Fax +32 030 9904733
- Water softening: this function is performed by the filter found in the lid. It eliminates hard
deposits in the water.
OPERATION
1. Before operating the appliance, always ensure that it is not connected to the power supply.
Remove the plug from the socket.
2. To fill the receptacle (1): remove it from the base (2) and turn it over, unscrewing the lid (6) in an
anticlockwise direction. Add demineralised or distilled water through the opening in the
receptacle. The water should obviously be free from impurities, at room temperature and clean.
Fill up to the maximum level indicated (the word MAX is printed on the opening as shown in the
diagram). Close the lid in a clockwise direction, sealing it carefully.
Warning: do not add oils or other essences to the water in order to prevent damaging and
compromising the appliance's performance.
Attention: do not fill the tank beyond the level required.
3. Place the receptacle on its base in the correct manner: ensure that the two arrows match up (on the
base and on the receptacle, found at the back).
4. Ensure that the knob is in the "0" position (off): and most importantly that the water has not
overflowed.
5. Plug the appliance in.
6. Turn the knob (3) in a clockwise direction to the "min" position and corresponding to the amount of
nebulisation required: minimum, intermediate or maximum. After a few seconds, vapour will start
forming.
7. When the water runs out, the nebuliser will automatically stop: to fill up the receptable again,
follow the instructions above in paragraphs 1, 2, 3 and 4.
8. For ozonation, press the "ozone" button (9) completely. To stop it, press it again and release.
9. To diffuse perfumes, extract the filter carrier from the base (11), moisten the felt (12) with a few
drops of essential oils and insert the filter carrier once again in its proper place. Be careful not to
add too much oil so as to prevent damage to the surface and the appliance itself. Do not add the
essential oils to the water in the receptacle or inside the unit.
10. In order to turn the appliance off, turn the knob to the "0" position, turning it in an anticlockwise
direction and unplug the unit from the power source.
11. After each use, empty out any water that may have collected in the tray inside the base and dry it
using a soft cloth
If the device is not to be used for a long time, remove the plug from the electric outlet and make
sure the tank and inside of the base are perfectly dry.
Warning: if you do not plan to use the appliance for two or more consecutive days, make sure that
the tank and the tray have been completely drained. Dry them to prevent the formation of bacteria and
algae in the stagnant water
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
11/36
Assembly page 11/36