After Finishing Using The Heater - Tiger PDR-A Serie Manuel D'instructions

7

After Finishing Using the Heater

1
Unplug
Unplug
2
Remove the lid
While pressing down on the attach / remove lever for the
lid, open and remove the lid by pulling the lid toward the
spout.
3
Discard remaining hot water
(Refer to p. 8)
• Move the unit to the kitchen sink and
Caution
then discard water slowly. Caution
for hot water may splash during this
operation.
• Watch out for hot water dripping from
the spout immediately after discarding
the hot water.
• Be sure to clean the inner container
and mesh filter. (Refer to p. 16)
15 15
4
Attach the lid
While pressing down on the attach/remove lever for the
lid, insert the hook-on part of the lid.
Unplug
Caution
• Do not leave hot water remaining
inside the container. This is to avoid
discoloration of the inside container or
foul odors from forming.
• Do not turn the spout downward with
the lid on, or discard hot water from the
hinge area. This is to avoid scalds from
splashing hot water or malfunction.
• Pay extra attention when discarding the
remaining hot water, as the mesh filter
may fall if it is not properly attached.