Dispensing Hot Water - Tiger PDR-A Serie Manuel D'instructions

4

Dispensing Hot Water

1
Press the
Unlock
2
Press the
Dispense
Place a container under the spout, and press the
key.
Dispense
Hot water continues to dispense while pressing the
key.
Dispense
※ After checking that hot water has stopped dispensing, remove the
container from the spout
※ If the unit is unplugged, hot water cannot be dispensed.
※ When water is boiled, air pressure increases in the container so
that the water dispenser may not produce a smooth water flow
immediately after it is boiled. Release the air pressure by opening
the lid and then dispense the water. Be cautious of steam.
※ Mineral deposits can build on the wall of the inner container, mesh
filter or pump unit, causing water to not dispense.
※ If the
key is not pressed for approx. 10 seconds after
Dispense
dispensing hot water, the unlock lamp will be turned off and the
unit will lock automatically.
Dispense
key
• Do not dispense when water level is
Caution
at "Refill water mark". Hot water may
splash when you dispense.
• Pay close attention when dispensing
hot water so as to not spin the entire
unit around.
key once.
Light
illuminates
key.
3
Press the
Unlock
The key. will be locked, and hot water cannot
Dispense
be dispensed even if the key is pressed.
■Refill water when level becomes low.
Be sure to refill water before it reaches [Refill water mark],
and close the lid securely. (Caution for hot steam when
refilling water. See p. 10)
Do not leave the unit without any water
Caution
inside, this is to avoid malfunction due to
boiling without water.
key once.
Light
turns o
12 12