Menu Operations - Drive MQ3200 Guide D'utilisation

6.3 Mounting the lanyard
Step 1. Put the end of the lanyard through the hole.
Step 2. Put another end of the lanyard through the
first one and then tighten it.
7 Operation Guide
7.1 Insert the two batteries properly to the direction, and then replace the cover.
7.2 Open the clip as shown in Figure 5.
7.3 Let the user's finger put into the rubber cushions of the clip
(make sure the finger is in the right position), and then clip the finger.
7.4 Press the switch button once on front panel.
7.5 Do not shake the finger and keep the user at ease during the process.
Meanwhile, human body is not recommended in movement status.
7.6 Get the information directly from screen display.
7.7 The button
When the device is powered on, pressing the button shortly will open the menu. When the device is power on,
pressing and holding the button will cycle the screen views. (see Figure 7)
Fingernails and the luminescent tube should be on the same side.
7.8 PI value display
When the device is powered off, long press the button
direction of the screen. when it enters the PI screen, you can read the PL
value. (see Figure 6)

Menu Operations

Click = short press the power button and press = prolonged push the power
button (1sec)
Press the power button with a prolonged push (1 second) to enter the Setting Menu Interface (see Figure 7). The
user can setup the following parameters in the Settings Menu -Turn on alarm, turn on pulse sound, alarm high-low
has three functions.When the device is powered off, the button will turn the unit on.
can change
PI
Figure 6