Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Care and Cleaning
Like most appliances, your water dispenser requires periodic maintenance for maximum
efficiency and performance and must be cleaned on a regular basis (i.e. every 4 months).
To maintain a hygienic environment within your water dispenser and prevent potential
formation (growth) of bacteria, we strongly recommend regular cleaning. A cleaning kit
is available through our Customer Service Department at 1-866-253-0447 or can be
ordered on line at www.greenwayhp.com.
Warning:
Unplug the dispenser before performing any of the following cleaning
procedures.
CLEANING THE OUTSIDE OF THE WATER DISPENSER
The outside of the dispenser can be wiped clean with a mild soap and water mixture.
Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with clean water and
then dry surfaces.
CLEANING THE DRIP TRAY
To remove, take the grill off the tray and firmly lift the tray up, dislodging it from the
guides. Drain and clean. The drip tray should be emptied and cleaned regularly to remove
spotting and any mineral deposits. Clean with vitapur
or a mild soap and water mixture. For tough deposits, add vinegar and let it soak until the
deposits come loose. Then wash, rinse and dry thoroughly. To replace, put the grill back
on the tray and slide the tray onto the guides (not dishwasher safe).
CLEANING THE CONDENSER
Vacuum or sweep away the dust from the condenser coils at the back of the dispenser.
For best results, you can purchase a brush designed specifically for this purpose from
your local appliance store. This will improve cooling and efficiency.
DRAINING THE RESERVOIRS
Drain the reservoirs before and after cleaning, when going on long vacations or if not
using the dispenser for long periods of time.
Important:
hot water until temperature drops to a safe level to avoid the risk of scalding.
1. Remove the water bottle.
2. Press both dispensing buttons until water no longer comes out.
3. Place a bucket beneath the drain valve on the back of the dispenser.
4. Remove the cap and plug from the drain valve and let the water flow into the
bucket. Replace the cap and plug. (A screwdriver or coin can be used to help
loosen the drain cap.)
Important:
5. Replace the water bottle (see Installing the Water Bottle).
All manuals and user guides at all-guides.com
Unplug the dispenser before performing this procedure. Dispense
Collect the water in a container, not the drip tray.
water dispenser cleaning solution
®
Publicité
Table des Matières
