vitapur VWD2266W Guide D'utilisation Et D'entretien page 7

Pre-Operation (continued)
INITIAL PRODUCT CLEANING PROCEDURE
The dispenser must be cleaned before the first use. To maintain a hygienic environment
within your water dispenser and prevent potential formation (growth) of bacteria, we
strongly recommend regular cleaning (i.e every 4 months). A cleaning kit is available
through our Customer Service Department at 1-866-253-0447 or can be ordered on line
at www.greenwayhp.com.
1. Unplug the unit.
2. Remove the bottle support collar (A), saturate a clean cloth with a water dispenser
cleaner or vinegar and wipe the inside of the reservoir.
3. Pour the water dispenser cleaner or a mixture of 4 cups / 1 L of vinegar with
4 cups / 1 L of hot water into the reservoir and wait 20 minutes.
Important:
remove the bottle support collar before pouring water or cleaning solution into
the reservoir.
4. Press both dispensing taps until water no
longer comes out.
5. Using a bucket, drain the reservoirs from the
drain valve on the back of the unit (H).
6. Rinse again with clean water, re-install drain
valve plug and cover.
7. Place bottle support collar back on top of
dispenser.
INSTALLING THE WATER BOTTLE
Important:
the top of the water bottle with a clean cloth. Water bottles can be purchased
from your local retailer.
1. Remove the protective cap from the end of the water bottle unless the bottle
has a puncturable cap or sticker.
2. Lift and turn the bottle upside down, placing it securely on the bottle support collar.
3. Press and hold both dispenser buttons until water flows from the dispenser.
Drain about 4 cups / 1 L of water before initial use. This does not need to be repeated
with replacement bottles.
4. Plug in the water dispenser.
5. Switch on the hot water power switch (rear of dispenser).
ANTI-LEAK BOTTLE SUPPORT COLLAR
The bottle support collar on your water dispenser is engineered with a special anti-leak-
proof system to prevent accidental loss of water, (flooding) as a result of inadvertently
installing a defective water bottle. Unfortunately, not all water bottles are created equal.
Almost all 3 and 5 gallon (12 &19L) water bottles are recycled and handled extensively
during cleaning, filling, and shipping. As a result, they are very prone to developing hair-
line fractures and pinhole leaks that are not always obvious to the end user until the time
of installation.
Important:
Never knowingly install a defective water bottle on a water dispenser.
Return immediately for replacement. If you are experiencing a leak, this simple
test will allow you to determine whether your water bottle or dispenser is the
source of the problem.
All manuals and user guides at all-guides.com
To avoid water overflow when cleaning your dispenser, always
Always wash your hands first before handling water bottle! Clean
A