Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CLEANING THE INSIDE OF THE DISPENSER
To prevent mineral deposits that can affect the taste and flow of the water and to ensure
proper product performance, your water dispenser must cleaned every 4 months.
1. Unplug the power cord and switch off the heating power switch at the rear of the unit.
2. Remove the water bottle and bottle support collar.
3. Drain the reservoirs (see Draining the Reservoirs).
4. Pour a water dispenser cleaner or a mixture 4 cups / 1L of vinegar with 4 cups / 1 L
of hot water into the reservoir and wait 20 minutes. If using a water dispenser
cleaning solution, please follow the manufacturer's instructions.
Important:
remove the bottle support collar before pouring water or cleaning solution
into the reservoir.
5. Press both dispensing buttons until water no longer comes out.
6. Drain the reservoirs.
Important:
7. Rinse with clean water.
8. Replace the bottle support collar and the water bottle (see Installing the Water Bottle).
GOING AWAY ON VACATION
When not using the dispenser for long periods of time or when going on vacation, unplug
the dispenser and drain the reservoirs (see Draining the Reservoirs). Follow Initial Product
Cleaning Procedures upon return and startup of the dispenser.
FREQUENTLY ASKED QUESTIONS
Q:
Why do I get a plastic taste from my dispenser?
A:
As with most new appliances such as coffee makers and kettles, there is often a
plastic taste upon initial start-up of the unit. To remove this taste, simply follow
the cleaning instructions outlined in Cleaning the Inside of the Dispenser.
Q:
What is the spike that goes into the bottle?
A:
vitapur® water dispensers feature a "piercing valve" as part of the bottle support
collar, providing added convenience for water bottle installation. Depending on
the water bottle supplier, some water bottles incorporate a self-piercing mem-
brane in the bottle cap for this specific purpose (ask your water bottle supplier
if your water bottle incorporates this feature). If your water bottle does not
incorporate this feature, the entire bottle cap must then be removed to eliminate
possible damage to the piercing valve.
All manuals and user guides at all-guides.com
To avoid water overflow while cleaning the dispenser, always
Collect the water into a container, not the drip tray.
Publicité
Table des Matières
